www.roller-revolution.com

Installing or replacing your bearings is a cinch with this bench-mountable Press/Puller for installing or removing bearings from all wheels. The largest diameter wheel the bearing press will accept is 70mm.

Just follow the simple instructions below and you’ll be back on the floor in no time!

Directions:

Puller- Start with the handle up and the long pin down (sideways). Then put the wheel on the outside, push the handle down and it pulls the bearing out. Repeat to pull out the other bearing.

Press- Stand the pin up and put a bearing down on the pin. Next put the wheel with the outside of the wheel (usually the printed side) facing up and put another bearing on the pin. Tip the pin down (sideways) and carefully pull the handle down. You may have to guide the bearings a bit to get started. The aluminum hub wheels may be a bit trickier than the nylon hub or no hub wheels. Do not use excessive force. A very small amount of silicone oil around the outside of the bearing usually helps ease them into the aluminum hub wheels.